Stitch count: the measure embroidery is priced by
Stitch count is the total number of stitches in an embroidered design, and it determines machine time, thread use and the price charged.
In short
Stitch count is the number of stitches in an embroidered design, and it sets machine time, thread use and price. Get the design digitized so you quote from the real count, not a guess.
Stitch count is the total number of needle penetrations in an embroidered design. A 5,000-stitch logo means the machine lowers and raises the needle 5,000 times. The count is read from the digitized machine file, and it turns into a price by dividing it by 1,000, multiplying by a rate per 1,000 stitches, then adding the garment and a one-off setup or digitizing fee.
How stitch count is worked out
The exact number comes from the digitized file. When artwork is digitized, the software produces a machine file and a production sheet that lists the stitch count. Free file viewers and the embroidery machine itself report the same figure, which lets you check that what was quoted matches what was received.
Before digitizing, you can only estimate. The working method is design area multiplied by a density factor for the stitch type. Satin-heavy designs run denser than fills, and run-stitch outlines run lightest. Stitch count is not the same as design size: a small, detailed 2-inch logo can hold more stitches than a large, simple one. Underlay, colour changes, shading and extra density all push the count up.
Why stitch count sets the price
Stitches drive two costs. Machine time rises with every stitch, and so does the thread consumed. A commercial machine sews at roughly 750 to 850 stitches per minute once colour changes and trims are included, so a 10,000-stitch design takes about 15 minutes. Higher counts also raise the risk of thread breaks and fabric puckering.
Shops therefore price in bands. The per-1,000 rate usually steps down as quantity rises, because setup is spread over more pieces and the same file simply runs again.
> Tip: Keep the garment as its own line on the quote. The stitching price then holds whichever garment the customer picks.
Worked example
The formula is:
Price per piece = (stitch count / 1,000) x rate per 1,000 + blank garment cost, plus a one-off setup or digitizing fee per design
Take an 8,000-stitch left-chest logo on 20 polos. Assume a rate of £1.50 per 1,000 stitches and a £9.00 polo. The stitching is 8 x £1.50 = £12.00, so each piece is £21.00 before margin. With a £25.00 digitizing fee charged once, the 20 pieces cost £420.00 plus £25.00, or £445.00. On a reorder the stored file means the fee is not charged again. These rates are illustrative; real rates vary by shop and market.
Why digitizing comes before an accurate quote
A guess such as "about 10,000 stitches" is how shops lose money on dense fills. The real count only exists once the design is digitized, so a firm quote needs the file, or at least a careful estimate with a margin for error. Until then, quote the estimate as provisional.
Building the bands into a tiered quote lets customers see how the price per piece falls as quantity rises. Embroidery and workwear businesses can start from the embroidery workwear quote template, and the wider trade is covered under garment decoration.