SEMA: the storage equipment industry body and what its codes cover
SEMA is the UK trade association for the storage equipment industry, publishing codes of practice for the design, installation, use and inspection of racking.
In short
SEMA is the UK trade body whose codes of practice cover racking design, installation and inspection. Quote and install with reference to them, and state the code and installer qualifications in writing.
SEMA is the Storage Equipment Manufacturers' Association, the UK trade body for the storage equipment industry. It publishes codes of practice, guidelines and technical bulletins that cover the design, installation, use and inspection of racking, written for the UK market. For a buyer, that means a way to judge whether a supplier, installer or inspector is working to a recognised benchmark. For a racking business, it means quoting, installing and inspecting with reference to those codes, and saying so in writing.
What SEMA is and what it does
SEMA describes itself as the leading voice for the storage equipment industry for over 50 years. It promotes the safe design, manufacture, installation and use of racking systems, publishes safety and technical standards, and represents the industry to the UK Health and Safety Executive (HSE). It also runs a membership scheme in which members are independently audited, including checks on legal and insurance documentation. Its work is aimed at the whole lifetime of the storage, not only the point of sale.
What the codes cover
The codes follow the life of a racking system:
- Design. The SEMA design code, first published in 1980, guides suppliers on structural analysis, the loads to consider, how components are tested and what factors of safety apply. Its codes of practice cover static and mobile racking, mobile shelving, cantilever racking and racking protection. In the UK, the quality assurance of a racking system rests on adherence to either the SEMA code or the European code EN 15512.
- Installation. SEMA runs the SEIRS training scheme so that installers are trained and assessed against SEMA standards and codes of practice. SEMA advises clients to ask to see an installer's SEIRS card.
- Use and inspection. Codes and guidelines set out how racking should be used and maintained. SEMA recommends a layered approach: staff trained to spot damage, a regular in-house inspection, and an expert inspection by a qualified inspector, such as a SEMA Approved Racking Inspector (SARI).
Why it matters when you quote and install
The responsibility to keep racking safe sits with the warehouse owner, who is expected to check installer competence, which is why buyers ask suppliers which code a design follows. A racking business that states the design code, load assumptions and installer qualifications on its quote gives the buyer something to check and avoids disputes later about what was priced and built.
On the quote, record the design code used, the stated pallet load per level and the installer's training. Keep a copy with the job so the same detail is available at handover. Racking firms can build this into their quotes, and capture installation and inspection checks as structured eForms rather than loose paper. See also the wider racking and storage industry page.
> Tip: Treat SEMA membership as something to verify rather than assume. Ask the supplier for current evidence, and ask the installer for their SEIRS card before work starts.
Related terms
SEMA is often mentioned alongside SEIRS (the installer training scheme), SARI (the approved inspector scheme), the named individual who makes sure inspections are planned, recorded and acted on.